James Robert is a fun-loving guy who loves to go on long drives while he is free. He loves to hear country songs while driving,...Read more
Today we discuss how to fix a blown speaker in car. A blown speaker is one of the most common problems in cars. It’s a common occurrence when you have a new car, and it’s especially frustrating when you can’t fix it. A blown speaker is usually caused by the wind noise coming from the speakers. It can be fixed in just a few minutes with this simple trick!
What is a blown speaker?
A blown speaker is when a speaker that is connected to power and audio cables suddenly stops working. It’s most often caused by strong winds that are blowing on the car and hitting the speakers, causing them to vibrate and eventually, break.
A blown speaker usually happens in cars with a 4-speaker system. If you have a car with an amplifier or subwoofer, it might not happen. When the speakers are vibrating, they’ll make noise intermittently, so you can still hear it but no longer hear the music or radio playing.
How do you fix a blown speaker?
The first step is to identify the location of the blown speaker. You need to find out which side of the car it is, and whether or not it’s just one speaker or more.
Once you know where the speaker is, we can start fixing! Take a small screwdriver and gently pry open the grill around the speaker. If you have a lot of rust, it will be easier if you use a hammer instead of your screwdriver.
Take out any screws that are holding on the grill. Carefully remove the grill and then remove any screws that are holding on the speaker. Take note carefully where everything goes so that it all fits back together when you’re finished!
Once your grill comes off and your speaker is free, try spinning it around to make sure nothing came loose during removal. You want to make sure that everything moves freely before putting your new grill back in place. This will ensure that no wires are caught over time!
Once everything is put back together properly, test your speakers and see if they work!
How to prevent a blown speaker in your car?
The first step to preventing a blown speaker is to place a hand towel in the cup holder. This will prevent any air from getting into your speaker and blowing it up.
Next, you’re going to want to buy a pair of foam earplugs. They come in a variety of colors and sizes, so make sure you get the ones that fit your ears best! Place them in your ears before turning on your car’s engine.
Finally, close all the windows before turning on the car’s engine. The less air that gets inside, the less likely it will be for it to blow up in your car!
These three simple steps should save you from blowing out your speakers again!
how to fix a blown speaker in car?
There are a few ways to fix a blown speaker in a car. One is to simply replace the blown speaker with a new one. Another is to try and repair the blown speaker. This can be done by checking the wires for damage and repairing or replacing them if necessary, and then re-attaching the wire leads to the speaker. Finally, another way to fix a blown speaker is to bypass it altogether by using an amp or headphone jack.
To solve how to fix a blown speaker in a car, First, identify if your car has a blown speaker. Next, turn off the engine and step out of the car. Then, use a flathead screwdriver or something similar to remove the round cover on the back of your radio/navigation unit. You’ll find the speaker inside. With your screwdriver, you can gently remove two screws from either side of the speaker. Then tilting it forward will expose an electrical connector that needs to be “re-terminated.” After that is done, replace the screws back in and reinstall the round cover. This should fix your problem!
A blown speaker is one of those annoyances you might not even know about until it happens. If you’re unlucky enough to have one, don’t worry! This post will walk you through how to fix a blown speaker (as well as some other common problems).